Trend

Hockey Stick Table YouTube Hockey stick furniture, Hockey stick, Hockey stick crafts

0

The third is in the middle of the top. Three cross beams make ensure the whole thing doesn’t rack. The hockey stick coffee table is one of the easier projects, making it a great place to start if you’re a relatively inexperienced woodworker. For that reason, the descriptions you’ll find below are a bit more in depth.

I built my son’s bench top to be 21” from the ground which I thought was comfortable for teens and adults. For the coffee table, I really recommend using a circular saw since there is no frame to conceal any uneven lengths! Using a circular saw and guide (if you didn’t heed my advice), cut both sides of the table.

Please see my other hockey stick … We’re going to stack the sticks 2×2 because you never know who’s going to sit on this thing just because they can. You can make it 2×1 or just use just one, but I advise against it. Attach 2 sticks together on the long edges first as shown in the figure using #6, 1.25″. Once you have two of those, you’ll need to use 1.5″ screws to get through the stick the long way thus creating one solid 2×2 leg.

If you are using a power saw, make sure your eyes, skin and lungs are protected from the dust! Cut each end of all sticks to ensure they have a flush, 90 degree cut on each end. I did my cuts using a compound miter saw, but a hand saw would work as well. This step is all about getting your 13 interior sticks cut to the appropriate length.

Please see my other hockey stick related ads. Place two cross beams about 2.75″ from the eventual length of your table top. This distance is important as this is where the legs will attach and determine your table’s stability. It doesn’t matter what it is, as long as it’s equidistant from both edges pacific rink player bag and big enough to get a circular saw in. If you’re smart, as discussed in Building, you’ll make it the width of your circular saw guide and won’t have to use another stick to act as a guide later. The total usable length of my 23 sticks was about 35 7/8″, so my cross beams start 2.75″ from that.

And, you may find that some stick shafts are composite material and hollow inside. Covering the ends with another sticks creates a nice finished look. I found that most of my used sticks had tape at the top of the stick that I wanted to remove. If I left the tape on the sticks it would be uncomfortable to sit on the bench and the sticks would not align against one another snug. So I removed the tape using a razor knife. Consider what you want to see and what is hidden.

Portrait of professional hockey player holds gaming stick isolated on grey background. The top was coated with a bartop epoxy. This is the step where you clean up your bench base to make sure it does not have any sharp surfaces and put some sealant on it. You need to put some paint or sealant on your base or it will rust.

Add casing around table with wood 1x4x8. You will need to cut 45 degree angles so that the pieces fit perfectly. Once you’re happy with the levelness of all the parts, go ahead and screw the pieces in place with #6, 1.25″.

Carefully drill 4 holes 1″ deep using a 7/64” drill bit. This step is where you finish the assembly of your bench. See the hand drawn diagram that attempts to show how the base will be assembled with a side view and a front view.

deepika

Comments

Comments are closed.